The system consists ofn.1
command and control unit, UDS-A  n.3
temperature sensors  n.2
Approval number E3 - 10R - 05 7194-00
The AK0745 is the system to detect and extiguish fire in the coach’s engine room and pre-heater room.
If you want protect too pre-heater room it’s necessary 1 more generator and 1 more temperature sensor.
to manage the thermic sensors
to manage the FPG generators
electronic set up for CAN-BUS
Real Time Clock system for the local retention of the alert events, sent from UDS-A control unit, by EEPROM memory card;
USB port on-board for the reading, by a PC, of the last 200 alert events occurred;
How AK0745 works?
The temperature sensors control the temperature and if it’ like fixed temperature, they send signal to UDS-A. UDS-A actives the generators. Extinguish fire in the engine compartment occurs in two different and consecutive moments. The AK0745 system works AUTOMATICALLY.
No maintenance required.
Watch how it works.
aerosol compound (each generator): 715 g or 90 g
715g generator’s dimensions: 197 mm x 127 mm (no bracket nor screw) - d. 165 mm
FirecomAutomotive’s generators are made in stainless steel.
control panel dimensions: 118 mm x 46 mm (widht mm 80)
AK0745 can have some optionals: LINK HERE to know or contact us.
Aerosol fire fighting system for historical archives and EDP1
the smallest of the family, only g 90 aerosol compound  1
Aerosol Generator g 400  03
Aerosol Generator g 850  04
Aerosol Generator g 1200
The AS generators are the new aerosol generators designed and engineered to protect very specific environments: SERVER ROOMS, EDP and ARCHIVES. The mechanics and physics of the AS generators were designed to prevent damage to paper and electronic circuit boards. The residue that may be deposited on the surfaces becomes dry once the system is activated and therefore can be removed easily and becomes noninvasive.
DISCOVER THE FULL RANGE OF PRODUCTS FOR FIXED SYSTEMS ON
It consists of:n.1
command and control unit, KUS  n.1
thermosensitive cable  n1-2
Ak0346 is the simpified aersol system designed from FirecomAutomotive. It's dedicated to protect: minibus, camper, bus.
How its work?
When the fire start in engine compartment, the thermosesitive cable detect the temperature and causes a short circuit, so the KUS activates the generators.
to manage thermosensitive cable that detect the fire;
to manage the FPG generator/s;
to control and check, with signal LED, the system
The Unit has a sound signal.
APPROVAL NUMBER: E3- 10R – 047076
Expedience to bus fleet. Not buy but hire the system.
- not system’s obsolescence
- pay on rate
- payment deductible
- technical assistance free
The AK0746 system consists of:n.1
LCD control and command unit. ULD  n.10
Temperature sensors  n.4
Simultaneous temperature detection of 5 different zones.
Simultaneous protection of 3 different zones.
The fire extinguishing capacity depends on the volume of the area to protect (this may be 90 g, 550 g, 715 g).
The compound is released into the engine compartment with delayed action of the second generator in respect to the first.
- management of heat sensors used to monitor temperatures
- analysis of signals sent by the heat sensors and control of pattern of temperature changes in each zone
- management of FPG generators
- supports CAN-BUS interface
- system control via LCD screen
- Real Time Clock system for local storage of all alarms detected by the ULD on one EEPROM memory card
- USB port on-board to read, using a computer, the last 200 events
- 12 V auxiliary battery to make the system completely independent from the vehicle battery.
- CAN BUS interface software
EOLO / EOLO 2
click on the above link to see our flame inhibitors range of products